Biplane Maiden FPV PE reactor

My first FPV flight real "glasses" with the installation of the reactor FPV EP Biplane. There are a lot of interference and noise into the mic, sorry. But I prefer to mask the sound of music. After the initial takeoff attempt caught the wheel, was not so bad off and landing have been much easier than expected. Flying at high speed on takeoff was a bit vague, but once you slow down, it was not bad for control. It is also the first aerial view of this siteaircraft that took a little advice. This is my current configuration. Aircraft: Reactor Biplane EP Electrifly Motor: brushless electric - 0.15 rimfire 45 amp ESC Flight Electrifly: 3S 11.1V 2200mAh Li-Poly Turnigy electronic air FPV On Screen Display: OSD Eagle Tree Pro Video: IDM-600 Camera (very programmable, etc. in stock for this video settings) for registration information:. ELogger Eagle Tree V3 GPS GPS v4 Eagle Tree Downlink: 900 MHz Audio / Video Transmitter Battery: 3S Turnigy11.1V 500mAh Li-poly on the ground FPV Electronics: Satellite Tracker: Eagle Eye Eagle Tree w / diversity RX1: 900Mhz w / modified SAW filter RX2 Patch Panel Antenna: 900MHz SAW filter actions dipole Recorder: Aiptek DZO-V58 Battery Eye the eagle and two receivers: 3S 11.1V 1500mAh Li-Poly RFI video glasses: glasses Modified Trimersion Thurs Battery glasses: Outrage XP 2s 7.2V 2500mAh Li-poly

See Also - Pioneer Elite SC-05 AV Receiver Sony STR-DG820

0 comments to "Biplane Maiden FPV PE reactor"

Post a Comment


Web hosting for webmasters